The verification results of our TASCAM products with Microsoft's "Windows 10 October 2020 Update" are as shown in the table below.
The results may differ depending on each computer's configuration.
Last update:November 20, 2020
| Result | Product | Firmware | Settings Panel / Driver | Note |
| OK | SERIES 102i | V1.02 | V1.00 | |
| OK | SERIES 208i | V1.02 | V1.00 | |
| OK | MiNiSTUDIO CREATOR US-42 | V2.30 | V2.33 | |
| OK | MiNiSTUDIO PERSONAL US-32 | V2.30 | V2.33 | |
| OK | iXR | V1.02 | V4.00 | |
| OK | US-1x2 | V1.00 | V4.00 | |
| OK | US-2x2 | V1.01 | V4.00 | |
| OK | US-4x4 | V1.01 | V4.00 | |
| OK | US-16x08 | V2.00 | V4.00 | |
| OK | Celesonic US-20x20 | V2.00 | V4.00 | |
| OK | TASCAM TRACKPACK iXR | V1.02 | V4.00 | |
| OK | TASCAM TRACKPACK 2x2 | V1.01 | V4.00 | |
| OK | TASCAM TRACKPACK 4x4 | V1.01 | V4.00 | |
| OK | UH-7000 | V1.08 | V1.02 | |
| OK | US-366 | V1.03 | V1.04 | |
| OK | US-1200 | V1.00 | V1.03rc1 |
| Result | Product | Firmware | Software / Driver | Note |
| OK | DR-05X | V1.10 | V1.00 | |
| OK | DR-07X | V1.10 | V1.00 | |
| OK | DR-40X | V1.01 | V1.00 |
| Result | Product | Firmware | Settings Panel / Driver | Note |
| OK | Model 24 | V1.60 | V1.20 | |
| OK | Model 16 | V1.30 | V1.20 | |
| OK | Model 12 | V1.11 | V1.20 |
| Result | Product | Firmware | Software / Driver | Note |
| OK | MX-8A | V1.10 | - | |
| OK | 202MKVII | - | - |
| Result | Product | Version | Note |
| OK | TASCAM DCP CONNECT New | V1.1.1 | |
| OK | TASCAM MX CONNECT New | V1.2.0 | |
| OK | TASCAM EZ CONNECT New | V1.2.0 | |
| OK | TASCAM SS250 CONTROL New | V2.0.0 | |
| OK | TASCAM Hi-Res Editor New | V1.03 | |
| OK | TASCAM DR FILE TRANSFER New | V1.00 | |
| OK | Poly/Mono Converter New | V1.00 |
INT
