-------------------------------------------------------------------------------------------------------------
Latest information
-------------------------------------------------------------------------------------------------------------
The most recent versions of the firmware/software for this unit are as follows.

Firmware: V1.02 (Previously V1.01 Updated at this time)

Remote control app
  TASCAM RECORDER CONNECT: V1.1.0

Software for Windows (ASIO Driver)
  TASCAM FR-AV series: V1.00

We request that you always use the latest software/firmware version for this unit.
For information about the latest software/firmware, check the product page (https://tascam.jp/int/product/fr-av2/support)

=============================================================================================================
F/W V1.02 (October, 16 2024)
--------------------------------------------------------------------------------------------------------------
< Maintenance items >
- When the INPUT was set to EXT and the REC LEVEL was set to maximum while nothing was connected to the camera/EXT/TC IN jack, a subtle cyclic noise could occur in CH 1. This has been fixed.

- When the REC LEVEL setting in the INPUT SETTINGS was changed using the TASCAM RECORDER CONNECT app,
 the REC LEVEL setting for channels that were not being operated would sometimes be set to 0 dB. This has been fixed.

--------------------------------------------------------------------------------------------------------------
F/W V1.01 (September, 30 2024)
--------------------------------------------------------------------------------------------------------------
< New functions >
- By pressing and holding the F3 button when the HOME screen is open, the phantom power status of each XLR input
 can be displayed and its power can be switched on/off now.

< Maintenance items >
- The phantom power setting would always be turned off when the power was turned on. This has been fixed.

- The speed when pressing the <</>> button has been adjusted to an appropriate speed.

- The input signal would be output as is when playback was paused. This has been fixed.

- The unit would become inoperable if an SD card that had been formatted on a computer or other device
 was inserted and then removed while a pop-up message was displayed. This has been fixed.

- Connecting the unit to a computer by USB when the REC PAUSE MODE was ON caused a pop-up message
 to appear that could not be closed. This has been fixed. 

- Operation stability has been improved in other ways.